WZ-34s customs, made from Type 87s & Tetrarcs

They are posted ! :-D

After using my Sd251s and Sd234s I realized I needed a couple more, cheaper units, to throw into battle as “disposbale guns” that I didnt mind losing if they never got a shot off. I also got tired of my 75mm AT guns being too weak, and my 88 flaks being too easy to hit, so I made my fav gun, the low-profile 88mm high-velocity AT gun by adding a nashorn gun to the base of a 75mm gun. I included a 75mm gun in the pic for comparison to my new 88. No worries, the Nashorn which lost its gun to make this, was put to good use - it became a Hummel.
  I was short on 75mm guns too, so 1 of these RSO’s is short a gun yet, to be made and added later.
  I made the RSOs by chopping Marders down to just the treads, and enough of the front and back hull to hold them together. Clear plastic (cut from a football card protector and sanded so glue would work on it) is the base for the superstructure, and provides the surface to mount the gun on. Balso is what the superstructure is made from, and paper is used extensively in it, especially to makes the hull sides smooth. Brass is used for the drivers seat. When I used my reference pics I noticed thier is stuff on the sides of these, not sure if it is loose legs for the guns, or some form of apparatus for folding the sdies of the vehicle down. But in either case, I just used some pieces from old model ships that gave an approximate look, and they are not 100% accurate. I just didnt like the completely flat sides I had, and had to add on something.

Here are some I made for a customer. Unlike the others I am about to post (that I made for myself), these are all permanently mounted armament, with a bit more attention to finer details. I snuck in a couple SD250s with mortars, cause they are permanently mounted weapons, but the 2 plain sand ones are for my own army.
  Also, the 2 flame throwers are for my army. Those have electical wire for the fuel hoses, and included are the fuel tanks and pumps. Those have more detail than I normally do for my own pieces - mainly cause I plan to use them in every game I play.

These 6 Luchs were Flamingos, with front ends resculpted, extra front hull armor, and rear smoke launchers removed. Puma turrets (as-is) have washers added underneath for better look and to allow turret to rotate without scraping engine covers. 4 in camo, sequencially numbered, for a customer, as is the crewed sd 234/4. The 2 plain sand Luchs are for my army, and will have interchangeable Luchs I turrrets.

Nice job PP, put that one in the display case.

Wow very nice stuff! much better than anything i ever saw.

Ok i would edit that post a bit. I saved it on my computer. I will PM you for details.