AARHE: Map files

My rationale for altering territory PF values was to attempt to make them more ‘relatively’ accurate. Part of the problem is that A&A is a simplified simulation. A simplified map and simplified PF values.
My proposed changes barely alter the map (I include a new South India Territory). Where I attempted an alteration was to spread PF values into ‘Siberian Territories’ , to better reflect Canadian PF values and to do the same with ‘Indonesian’ Territories.
Kreuzfeldt, I am not or was not basing my alterations on ‘oil’ or ‘resources’ only. A&A, in all it’s various incarnations, is a simplified simulation.
As to your numbered points;

The map given is the map that must be worked with. I had no thought of population as opposed to resources. My alterations to PFs are my opinion of the relative values of the Territories affected. There is an emphasis on Canada to more accurately, imho, reflect it’s component parts. I am a Canadian so I wish to see a better relative accuracy there (here). The maps and the PF resource values may not be entirely accurate for the original territories (or even for my suggestions). Again, A&A is a very simplified simulation. Compromises have to be made. It is a fact that capital Territories, especially, in Europe (& for Japan territory) HAD the overwhelming or virtually all the concentrated industry (& resources). This explains where the Factories are placed. I see no problem, therefore, that PF values for France, West Germany or Russia are increased somewhat. You think the UK (England territory) should be worth considerably more than ‘France’ (Paris) or West Germany (the Ruhr)? Your choice, not mine.
4)My intent was to give ‘relative’ value to as many ‘spaces’ (territories) as possible. This is why I added value to some of the ‘Siberian’ territories in the USSR. This is why I spread the Indonesian values out to a few more spaces. The idea of ‘oil’ is subsumed into the game. It is not necessary to make Rumania so valuable (6 pts) as you suggest. I could be incorrect about the relative value I give to the Urals & NovoSibirsk, however, I observe that the ‘Urals’ space  reflects the ‘northern (arctic) Urals’ (hardly the space for industry). NovoSibirsk space could have a higher value. Note, Kreuzfeldt, the actual names used in the USSR & the fact many of these ‘spaces’ would have had a value greater than 0. Hence, I place a number of ‘value territories’ in the spaces that reflect ‘Siberia’ or parts thereof). So, I am trying (tried) to reflect an importance for Siberia (more, in fact, than the original map).
I did not alter the PFs (total points) of any ‘Nation’ from the original game. I simply attempt to offer a more accurate ‘relative’ PF value for certain Territories. I created a few new Territories but only where logical and where able (using the original map given).
Some players may dispute my new ‘relative’ PF Territory values. I am sure some values might be altered, however, not by much, imho.
As to A&A maps? All I will say is they have improved from the original but they still present ‘problems’.
Again, A&A is a simple simulation and ‘compromises’ are (& will) be made. The above Global 1940 Map alterations are my suggestions to making this map a little bit ‘better’.

Thanks! I mostly agree with your comment about per-dice research efficiency; the only reason I didn’t include additional penalties for triple-stacking your scientists is for the sake of simplicity. If you want to play with a -3 penalty, or (even better) a -4 penalty that rounds up to a -3 penalty if you roll three 1’s, then go right ahead!

Giving each Axis nation 3 tokens and each Allied nation 2 tokens tends to give the Axis an early edge in research (they will manage their first couple of breakthroughs earlier than the Allies will), but then the Allies will start to catch up and then overtake the Axis later in the war, because the Axis scientists (on average) will be more “crowded” and will take more stacking penalties.

You could bump Radar to 14 pts. or even to 16 pts. if you really want to, but there are limited opportunities to make full use of the potential synergy. E.g., suppose Germany is using a “Dark Skies” approach to ward off Allied fleets with its enormous Nazi bomber squadrons. Britain might want both Radar and Anti-Aircraft Cruisers to help protect its fleet. Russia, on the other hand, only needs Radar – they’re not going to build any cruisers. Similarly, Russia doesn’t have much use for Jet Fighters, since if it’s suffering from a strategic bombing campaign, it won’t be able to afford much in the way of extra fighters. There’s also the concern that “Heavy Bombers” has always been an overpowered technology in every version of Axis & Allies that had tech. I tried to err in the opposite direction by making the anti-aircraft techs roughly as powerful as the aircraft-enhancement techs!

There is an “Improved Artillery” tech in some of the OOB versions of Axis & Allies, and I’ve never seen anyone buy it, except maybe Russia, who really does have to count every dollar and might not be able to afford enough artillery to fully power its infantry stacks. It is really challenging to fully exploit the advantage of 2:1 artillery support is that it’s really hard to maintain the desired ratio. E.g. if I have a stack of 10 infantry and 5 artillery, then after one round of combat, I probably have something like 2 infantry and 5 artillery, and the extra artillery support becomes moot. It stays moot on defense, too, when those artillery try to hold the ground they just captured. But if I have a stack of 20 infantry and 5 artillery instead, then my army is hugely inefficient – even with 2:1 artillery support, I’m only generating 40 pips of punch on 25 units, so I’m going to give you multiple rounds of combat in which to score hits and wear down my army.

You get the same problem in reverse if you want to only boost the artillery’s native attack power. With a stack of, e.g., 8 infantry and 3 artillery, the tech would only give you +3 pips of punch – it’s just not very exciting. You could try attacking with a stack of all artillery, e.g., 10 artillery for $40, but that just seems weird and un-thematic.

Anyway, let me know if you try out the rules, with or without some modifications! I’d be curious to see how they work in live play. I’m defending my rules so you have the benefit of my opinions, but they’re just opinions, and ultimately the house rules are there for everyone to enjoy however they like…if you think you’ll have more fun tweaking the costs or nerfing a couple of the techs, then go with what seems fun! :-)

Ever tried this?

as we are learning now, 1940 is an easier year to set up, because the Axis and Allies are a little more clearley defined

Try using ANZAC pieces to represent France on the AA 50th board

France gets ….

France, Morocco Algeria, French West Africa, French Central Africa, Madagascar, and French Indochina.
A french infantry in Trans-Jordan to represent Syria, and a french canadian infantry too.

If paris falls on the first turn then at the end of the victorious nations turn (Germany or Italy) do the following. Roll a die, any French units AND/or territories (that do not contain other allied units) convert to axis units if they are the able to be reached from france by any route in the number of game spaces shown on the die. If other allied land units are present (UK) then those french units remain free french. French naval vessels are scuttled IF they convert and vessels of any other nation are present (including the allies)

On a roll of a 1 Germany gets the French Mediteranin fleet (Destroyer and Transport) and the french atlantic fleet (if the uk player took its units there as casualties and only french vessles remained after combat)
On a roll of a 2 they also get Morocco Algeria
On a roll of a 3 they cant claim any more units because there are no elegible units 3 game spaces away from france
On a roll of a 4 french west africa converts to the axis, syrian french do not convert because there are UK units there.
On a roll of a 5 french equatorial africa also converts
On a roll of a 6 Madagascar also converts.

Tekkyy? where are you ?

It DOES read one level of technology transferred between one SIDE per turn.

so if axis as a group obtain 4 tech slots, only one level can pass from one nation to another that turn.

Soviets don’t share or receive secrets.

Yeah you’re right, finished, not finalized…

replace
“its income cannot be spent in other territories.
That income and only that income can be spent in its IC or VC during purchase units phase this turn.
That income is forfeited if not spent this turn.”

with
“The blockaded territory’s income can only be spent in its own VC or IC. Income from other territories may not be spent in the blockaded territory’s VC or IC.
If the blockade territory’s income is not spent this turn it is forfeited.”