AARHE: Map files

@black_elk said in Working on a New Map 40/41: Seeking Suggestions:

perhaps with some map making type tutorials in the same way that Pact of Steel 2 taught how to create an xml and such

:+1:

My rationale for altering territory PF values was to attempt to make them more ‘relatively’ accurate. Part of the problem is that A&A is a simplified simulation. A simplified map and simplified PF values.
My proposed changes barely alter the map (I include a new South India Territory). Where I attempted an alteration was to spread PF values into ‘Siberian Territories’ , to better reflect Canadian PF values and to do the same with ‘Indonesian’ Territories.
Kreuzfeldt, I am not or was not basing my alterations on ‘oil’ or ‘resources’ only. A&A, in all it’s various incarnations, is a simplified simulation.
As to your numbered points;

The map given is the map that must be worked with. I had no thought of population as opposed to resources. My alterations to PFs are my opinion of the relative values of the Territories affected. There is an emphasis on Canada to more accurately, imho, reflect it’s component parts. I am a Canadian so I wish to see a better relative accuracy there (here). The maps and the PF resource values may not be entirely accurate for the original territories (or even for my suggestions). Again, A&A is a very simplified simulation. Compromises have to be made. It is a fact that capital Territories, especially, in Europe (& for Japan territory) HAD the overwhelming or virtually all the concentrated industry (& resources). This explains where the Factories are placed. I see no problem, therefore, that PF values for France, West Germany or Russia are increased somewhat. You think the UK (England territory) should be worth considerably more than ‘France’ (Paris) or West Germany (the Ruhr)? Your choice, not mine.
4)My intent was to give ‘relative’ value to as many ‘spaces’ (territories) as possible. This is why I added value to some of the ‘Siberian’ territories in the USSR. This is why I spread the Indonesian values out to a few more spaces. The idea of ‘oil’ is subsumed into the game. It is not necessary to make Rumania so valuable (6 pts) as you suggest. I could be incorrect about the relative value I give to the Urals & NovoSibirsk, however, I observe that the ‘Urals’ space  reflects the ‘northern (arctic) Urals’ (hardly the space for industry). NovoSibirsk space could have a higher value. Note, Kreuzfeldt, the actual names used in the USSR & the fact many of these ‘spaces’ would have had a value greater than 0. Hence, I place a number of ‘value territories’ in the spaces that reflect ‘Siberia’ or parts thereof). So, I am trying (tried) to reflect an importance for Siberia (more, in fact, than the original map).
I did not alter the PFs (total points) of any ‘Nation’ from the original game. I simply attempt to offer a more accurate ‘relative’ PF value for certain Territories. I created a few new Territories but only where logical and where able (using the original map given).
Some players may dispute my new ‘relative’ PF Territory values. I am sure some values might be altered, however, not by much, imho.
As to A&A maps? All I will say is they have improved from the original but they still present ‘problems’.
Again, A&A is a simple simulation and ‘compromises’ are (& will) be made. The above Global 1940 Map alterations are my suggestions to making this map a little bit ‘better’.

@Argothair:

Should it take more turns, in general, to move a basic unit by land, by sea, or by air? Why?

For whatever it’s worth, sea transporation and land transportation and air transportation in the real world exist on a continuum in which speed is inversely proportional to tonnage.  Shipping by sea is (and has been since ancient times) the cheapest way to move vast quantities of goods over great distances, giant supertankers being a good example of this principle, but it has the disadvantage of being slow and (for obvious reasons) of being limited to oceans and seas and coastlines and certain rivers.  Shipping by air is the fastest method, but it’s expensive and it involves much smaller payloads; it also has limitations imposed by landing strip requirements.  Helicopters are more flexible in this regard than fixed-wing aircraft, but they have terrible fuel consumption, a short range, high maintenance costs and small payload capacities.  Transporation by land is roughly half-way between those two extremes.  Of the two land options, rail shipping is in many ways superior because combines fairly high speed with low fuel consumption and large payload capacity, but it’s limited to places where rail lines exist.  Trucking is more versatile because there are more roads in more places than rail lines, and in a pinch some trucks can operate off-road, but they’re not as efficient at moving tonnage than trains.

@Chiclet:

One more thing:

Aircraft carriers should not cost 12.  They are essentially worthless without a fighter or two so to make a them worth while you would need to spend a minimum of 22 IPC. way too much.

I’d bump it down to 9.

Dont think so. Imho they are already to cheap at 12. I don’t know why they reduced the price, as it was 14 before. Reducing this even more would make other naval units like battleships totally unnecessary.

So heres my latest map for A&A 1914. Includes East Prussia and all correct borders, Has some Zones for Askarideployment in Africa.

I kept Albania, neutral Greece and Moscow as Russian Capitol.

1914Balance.png

1.  Where did you get the “buttons” your pieces are glued to?  I can’t find anything thats close.  I even thought about painting pennies or nickels (US 1 cent or 5 cent pieces) to glue my pieces on. Would be cheaper than buying anything i’ve seen.

Washers bought from “do-it center” Hillman fender washers– 1/8x3/4— item # 290001— box of 100 for $5 bucks…you can find them on internet and order

2.  Where did you get your pieces from.  And what size are they?  They look like 1/72 or 15 mm.  Having trouble finding good quality but inexpensive artillery, tanks, planes and ships.

Its all skytrex.com stuff  15mm infantry, 1/285 miroarmor, 1/2400 scale naval… about a buck each piece and if you place a large order shipping is free

3.  What size did you blow your map to?

60x36 from AAA flag and banner for about $155 bucks printed on 1/4 thick plastic sheets with vinyl decal applied. www.AAAflagandbanner.com  you send the link and money they print and ship.

yep

Yes private emails and a few PM’s its been going on for about 4 months. Its usually ok, but that last one was rather long. I answerd the first 5 questions and felt it would take me alot of time which i didnt have.

thanks again.