Recruiting stations at least?!
Global 1940 Combat Engineer Unit
-
For now, the Combat Engineer unit is play tested only for Global 1943.
One major reason is, that most other specialized units are already on the game board in the Global 1943 setup.
This makes it easier to manage the Combat Engineer unit - and assign tasks for this unit when it enters the game.
Depending on play test results, the Combat Engineer unit will initially be part of the Optional Rules section in the Axis & Allies Global 1940 House Rules Expansion - earmarked for use with Global 1943.
-
@the-captain yea makes sense. I was gonna roll a 43 triplea test, as all are the same for both 40 regular and it. Probably do it next update test game. Too many changes this time.
Eddie Van Halen tribute distracting me right now lol
-
By now, we have completed 4 games of Global 1943 with the Combat Engineer unit.
So far, Germany has from game start produced the Combat Engineer unit.
During the fighting on the Eastern Front, the German Combat Engineer unit is highly effective - transporting Landmines & Artillery units - as well as preparing Landig Strips for Fighter & Tactical Bomber units.
We have even seen an attempt to move the Minor Industrial Complex in France further to the East.
The United States also produced the Combat Engineer unit, mostly for constructing Landing Strips in Africa and a few islands in The Pacific.
A question came up during Play Testing:
“Does a Landing Strip, constructed by a Combat Engineer unit, increase the Flight Range of Air Units?”The answer is no.
A Landing Strip is an “improvised” airfield for Air units - constructed with only the materials at hand in order to make the Air unit land - and without extensive support units, fuel, facilities etc. that an Air Base contains. -
@the-captain right on. I’m almost done with the test game. I’ll go ahead and add it as an optional rule as well as the Desert Army when I do the next update.
Should I just hardwire it into 43 ?
-
Great,
Yea - you could hardwire it into Global 1943 - I’m convinced that both the Combat Engineer unit as well as the Desert Army formation will be permanent in both G40 and G43 versions.
-
@the-captain right on I’ll keep it as an option for 40 but turned on to start with.
-
Updated to triplea
- Combat Engineer
Adds the Combat Engineer Unit. Use Edit for moving Minor Factories and removing Landmines. Also for landing at Landing Strips.
Land the Air Unit in a legal area and then edit after Non Combat Move.
Unit Image courtesy of Hepps.
Forgot about making it an option lol. So just don’t use if you don’t want to : )
- Combat Engineer
-
Axis & Allies Global 1943 game no. 10 is played this coming Saturday.
This is the final play testing game with the Combat Engineer unit.
Rules concerning this unit will be revised & ready for use next week.
-
Man, I can’t believe how far time has passed.
-
The Combat Engineer unit has now been fully play tested for Global 1943 as well as Global 1940.
The Combat Engineer unit will be part of the Axis & Allies Global 1940 House Rules Expansion.
Note:
The Combat Engineer unit is part of the Optional Rules in the Axis & Allies Global 1940 House Rules Expansion rulebook. -
B barnee referenced this topic on
-
Are the markers for the combat engineer unit already available for cut out and use?
-
The markers for the Combat Engineer unit will be ready for print & use within 24 hours:muscle:
-
Good!
-
Markers for use with Combat Engineer units have been attached to the first post on this thread.
-
The rules concerning Combat Engineer units have been updated.
A few rules clarifications are incorperated in the rules - and the defense factor is decreased to “2”.
The updated rule is attached at the first post on this thread.
-
@The-Captain Right on. So it can’t move a Arty in CM and get supported now ?
During the Combat phase, the Combat Engineer unit
can be supported by an Artillery unit, and thereby
attack at “2”.
This Artillery unit can be “transported” by the
Combat Engineer unit during the Combat Movement
phase – or the Artillery unit could come from
1
another space – and support the Combat EngineerWould have 0 Attack Factor ?
When a Combat Engineer unit performs tasks no. 1,
2, 4, 5 and 6 the Combat Engineer unit’s attack
factor is eliminated.
In other words: a Combat Engineer unit cannot
attack when it performs another task – except task
no. 3: Blitz Movement.
It can however be chosen as cannon-fodder. ed-text -
The rules concerning Combat Engineer units have been re-clarified.
The latest updated rule is attached at the first post on this thread.
-
-
The Combat Engineer units was used with great succes during the 3rd Northern Europe Axis & Allies Wiking-Con.
Game Reports with pictures will soon be posted at the Global 1940 & 1943 Expansions Game Report Thread
-
@The-Captain All 3 LMs have to be placed on the same border correct ? I thought I saw that somewhere but don’t see it in this thread or the pdf
- Landmines:
During the Non-Combat Movement phase, a Combat
Engineer unit can move up to 3 un-armed
Landmines – at a distance of up to 2 spaces – and
place those Landmines directly at any border/line –
even if this territory has been captured during this
turn.
- Landmines:
Suggested Topics
