Question with US IPC setup

Thanks Midnight_Reaper this clears up the question. (Sorry I didn’t get back sooner, but I actually forgot that I had posted this question.)

Thanks for the help and thank you!

Can’t wait!

Witt is correct. But just to add that if you are transporting your own units (rather than an allies’) you can indeed load and unload in the same turn. Witt mentions the 2 move per turn limit in this regard, which may (of course) mean that you have not reached your final destination.

Welcome indeed to our forum jalk65.

No doubt an unnecessary clarification, but to avoid any new players getting the wrong end of the stick - fighters that start or finish at sea must have a carrier in that sz. Up to 2 fighters per carrier.

Thanks Wittmann!

Great! Thank a lot

@Sir_Cala:

A submarine either attacks or submerge.

If it attacks and hits a unit with a surprise strike with no destroyer present. The ship that is chosen to be hit does not defend and is removed from the battle board. Exceptions are Battleships. They take 2 hits and the second hit removes of the battleboard.
Repeat steps 2-7 if combat continues.

If a submarine submerges it is not involved in any sea battle.

so is that to say that if a sub scores a hit with a surprise attack it destroys whatever unit it hits, with the exception of battle ships which would need to be hit by two surprise attacks? cause battle ships have a defence of 4

General Combat Sequence
Combat takes place over a number of rounds. Each battle round consists of several steps.
1. Place units along the battle strip
2. Submarine surprise strike or submerge (sea battles only)
3. Attacking units fire
4. Defending units fire
5. Remove defender�s casualties
6. Press attack or retreat
7. Conclude combat

step 2.
submarine surprise strike or submerge (sea Battles only)
This step is specific to attacking and defending submarines.
Before the general sea battle takes place (steps 3�5), both attacking and defending submarines choose to either make a
Surprise Strike die roll or submerge. However, if your opponent has a destroyer in the battle, your attacking or defending
submarines cannot submerge or make a Surprise Strike. Combat proceeds normally, and your submarines fire along with your
other units in step 3 or 4.
Submerge: Attacking or defending submarines that choose to submerge are immediately removed from the battle strip and
returned to the game board in the contested sea zone, removing them from the rest of that sea battle.
Players on both sides have to decide whether attacking and defending submarines will fire or submerge before rolling any dice.
The attacking player decides first.
Surprise Strike: Each attacking submarine conducting a Surprise Strike rolls one die, scoring a hit on a roll of �2� or less.
After the attacker has rolled for all attacking submarines, the defender chooses one sea unit for each hit scored and moves it
behind the casualty strip. (Submarines cannot hit air units.) Then each defending submarine conducting a Surprise Strike rolls
one die, scoring a hit on a roll of �1.� After the defender has rolled for all defending submarines, the attacker chooses one sea
unit for each hit scored and removes it from play.
Once all Surprise Strike rolls have been made, remove the defender�s casualties. This step is over for this round of
combat. Repeat this step during each round of combat as long as there are attacking and/or defending submarines and no
opposing destroyers. Any hits made during this step that do not destroy units (such as battleships) remain in effect until the
end of the combat.
Note: In both cases, attacking or defending, transports can be chosen as casualties only if there are no other eligible units.
You cannot choose submerged submarines as casualties since they have been removed from the battle.