Thank you for sending the map to my printer. I have been testing scenarios out with my A&A using my 1942 second edition. I just have been using sticky note paper to mark my Italian territories. I used the game pieces from my anniversary addition for the Italian pieces. I also added have tracks: cost is IPC 5. Attack 2, defend 2 as tanks cost 6 IPC in this version. Its nice to spend 5 IPC on an actual unit other than an AA gun. No artillery bonus on half track in this version
I also added the recruitment center from zombies.
Please see the chart below
MOBILIZATION ZONE
UNIT STATS COST MOVE ATTACK DEFENSE
LAND UNITS
INFANTRY 3 1 1 2
ARTILLERY 4 1 2 2
HALF TRACK 5 2 2 2
TANK 6 2 3 3
ANTIAIRCRAFT ARTILLERY 5 1 0 1
RECRUITMENT CENTER 10 0 0 0
INDUSTRIAL COMPLEX 15 0 0 0
Need advice for custom dice DIY
-
I’ve recently bought 96 dice because I wanted to make custom hit/miss dice for Global 40. I bought these dice from amazon and they’re plain blank and white dice.
I don’t have a lot of experience with DIY projects but I have access to a lot of good tools so I’m looking for advice regarding techniques on how to mark and repaint the dice I bought.
For the marking, I was thinking about using a rotary tool to carve a little dot.
The real challenge is the painting. I looked a lot on internet and I can’t seem to find a technique for painting on plastic that everyone agrees on, but here’s what I have so far.
- Wash the dice to remove any grease that could be on the surface
- Use very fine sandpaper or some sort of abrasive to remove the protective finish that is on the dice right now and offer a better surface for the new paint to stick
- Wash the dice again the remove the dust from the paint removal
- Apply one or a few (I’m not sure about this one, I’ll read what is suggested on the can) of primer
- Apply a few thin layer of the color I want on the dice
- Paint a white dot in the carving I made earlier with a fine brush
- Apply one or a few (not sure about this one either, something will be suggested on the can) of clear finish to protect the paint
Any correction or suggestion would be very welcome!
-
@LebaneseWarlord said in Need advice for custom dice DIY:
I’ve recently bought 96 dice because I wanted to make custom hit/miss dice for Global 40. I bought these dice from amazon and they’re plain blank and white dice.
I don’t have a lot of experience with DIY projects but I have access to a lot of good tools so I’m looking for advice regarding techniques on how to mark and repaint the dice I bought.
For the marking, I was thinking about using a rotary tool to carve a little dot.
The real challenge is the painting. I looked a lot on internet and I can’t seem to find a technique for painting on plastic that everyone agrees on, but here’s what I have so far.
- Wash the dice to remove any grease that could be on the surface
- Use very fine sandpaper or some sort of abrasive to remove the protective finish that is on the dice right now and offer a better surface for the new paint to stick
- Wash the dice again the remove the dust from the paint removal
- Apply one or a few (I’m not sure about this one, I’ll read what is suggested on the can) of primer
- Apply a few thin layer of the color I want on the dice
- Paint a white dot in the carving I made earlier with a fine brush
- Apply one or a few (not sure about this one either, something will be suggested on the can) of clear finish to protect the paint
Any correction or suggestion would be very welcome!
Guys use RIT dye for color. Go to Siredblood’s custom dice you tube video. Shows how he used a jig to spot hole dice and then dye them
Suggested Topics
