What are your tips for making custom axis and allies boards?

@sweetchops27 Surprised that Senussi isn’t on here as an Ottoman-Aligned Territory (land area could be in-between Cyrenaica and Egypt) . If you don’t want to add more territories, you could very well replace Cyrenaica with it and make it north and south instead of west and east.

An example here is how we fill this one up.
I was formerly playing as Germany, so below is my movements.
For sea zone, we use the same number (Eg from sea zone 93>99)
If transport, we will write 93 > S france(pick up 2 troops) >96 (disembark on Tobruk)
For land, we will just write the name of land (from a to b)
Next we will be marking the troops to move.
If it’s all units in the land to move, we just write “all”
Adding the concept of bidding, you’d get lots of fun when you either evade an attack, or managed to “pin” your enemies.
Hope this helps.

@zhirong-fu 145447164_10222966829931692_1275817621394509162_n.jpg

@LebaneseWarlord said in Need advice for custom dice DIY:

I’ve recently bought 96 dice because I wanted to make custom hit/miss dice for Global 40. I bought these dice from amazon and they’re plain blank and white dice.

I don’t have a lot of experience with DIY projects but I have access to a lot of good tools so I’m looking for advice regarding techniques on how to mark and repaint the dice I bought.

For the marking, I was thinking about using a rotary tool to carve a little dot.

The real challenge is the painting. I looked a lot on internet and I can’t seem to find a technique for painting on plastic that everyone agrees on, but here’s what I have so far.

Wash the dice to remove any grease that could be on the surface Use very fine sandpaper or some sort of abrasive to remove the protective finish that is on the dice right now and offer a better surface for the new paint to stick Wash the dice again the remove the dust from the paint removal Apply one or a few (I’m not sure about this one, I’ll read what is suggested on the can) of primer Apply a few thin layer of the color I want on the dice Paint a white dot in the carving I made earlier with a fine brush Apply one or a few (not sure about this one either, something will be suggested on the can) of clear finish to protect the paint

Any correction or suggestion would be very welcome!

Guys use RIT dye for color. Go to Siredblood’s custom dice you tube video. Shows how he used a jig to spot hole dice and then dye them

@Always-Wanderer

Thank you for providing this!

Matt H.

Hi,

yeah, i’ve seen that…i just wanted to make them myself :)

it goes very well with my terrain board…

Any customization is welcome on this thread.

Your other question would probably go in one or two places.

You can either ask your question on the thread, "other axis and allies variants, "  or the thread, "house rules, " which might be a better place for it.

That would be my guess, but others may have suggestions as well.

I hope that helps. :-)

John

The next group of infantry, will be, DESERT LIGHT INFANTYRY.

Until next time.

Cheers!

John

Hello everyone,

I have been getting some requests for the air base & naval base icons I used for my custom map, so here they are…