Custom carriers from OOB's and painted pieces

@LebaneseWarlord said in Need advice for custom dice DIY:

I’ve recently bought 96 dice because I wanted to make custom hit/miss dice for Global 40. I bought these dice from amazon and they’re plain blank and white dice.

I don’t have a lot of experience with DIY projects but I have access to a lot of good tools so I’m looking for advice regarding techniques on how to mark and repaint the dice I bought.

For the marking, I was thinking about using a rotary tool to carve a little dot.

The real challenge is the painting. I looked a lot on internet and I can’t seem to find a technique for painting on plastic that everyone agrees on, but here’s what I have so far.

Wash the dice to remove any grease that could be on the surface Use very fine sandpaper or some sort of abrasive to remove the protective finish that is on the dice right now and offer a better surface for the new paint to stick Wash the dice again the remove the dust from the paint removal Apply one or a few (I’m not sure about this one, I’ll read what is suggested on the can) of primer Apply a few thin layer of the color I want on the dice Paint a white dot in the carving I made earlier with a fine brush Apply one or a few (not sure about this one either, something will be suggested on the can) of clear finish to protect the paint

Any correction or suggestion would be very welcome!

Guys use RIT dye for color. Go to Siredblood’s custom dice you tube video. Shows how he used a jig to spot hole dice and then dye them

@jeffcamis:

Can someone recommend a printer for a custom map make that doesnt charge 250 plus.  Im located in north jersey area.  I need a custom map for aa 50th anny edition.  I have tge file i want to use.  Thanks. Jeff.

I’m not from New Jersey, but I am in America… I got my Scrim/Outdoor Banner Vinyl AA50 map made for like $60.

Did it at FedEx Office Print & Ship Center… I would imagine you have one like that in Jersey… also maybe try a Kinko’s if you have one of them. If you can’t find one locally, try the FedEx online shop and have it sent to you.

If you are really looking for a good finish on all your HBG pieces, you could buy a couple small cans of differing lacquers and test each one. $20 should get almost 3 cans worth. It may be a waste to some degree, but at least you can know for sure which one works best.

I have a flat Testors lacquer/sealant spray that I used on Tall Paul’s finished pieces. Granted, these were painted first, so the effect may be thrown off. However, I will say that I did not observe any level of gloss on the HBG or OOB pieces after I applied it. It was quite flat as advertised. FWIW.

Great Idea!

But it doesn’t work for me… same problems as Athlim had… Can anyone help?

@jwo1984:

hey guys, so I was searching some camo desert schemes for HBG’s Valentine medium tank and came across this one. � However looking at the sculps I knew it would be tough to paint these blue lines in because most of the tank is all track! so I cut out and shaped some track guard armour like the photo below just using some clear flexible plastic and glued in too the sides…making these two tanks mk II’s which look to have had the side armour as a pose to the Mk V that HBG has sculpted.

I’m sure whatever you do too it, it will turn out great. Can’t wait too see it painted. Good luck buddy! :-D

Does he happen to have a website or other example of work?

@Tall-Paul amazing craftsmanship

Thank you Paul. These all look very cool. Looks like I have a few options.

Jon