Cyanight's Customizations

@The-Captain
I used 3mm thumb nuts drilled out to fit 3mm acrylic rods. I used a number of 3d printed jigs for cutting the rods, assembly of the stands and gluing the magnets. If I remember later I’ll attached some pictures of the jigs/stands

@the_good_captain

All my boards are on 5mm foamex boards.
Waterproof, fade proof, and really hard wearing

Thanks for watching!

New Sets Arrived today.

Republican Spain/National Spain
Balken Crosses for Armor
Balken Crosses for Aircraft
UK Roundels for Aircraft

check em out.
combatminiatures.org

balken armor.jpg
German Aircraft Crosses.png

YGH…

It will add the enthusiasm for sure to do more videos!

BH

Any customization is welcome on this thread.

Your other question would probably go in one or two places.

You can either ask your question on the thread, "other axis and allies variants, "  or the thread, "house rules, " which might be a better place for it.

That would be my guess, but others may have suggestions as well.

I hope that helps. :-)

John

If you go to a local printer, make sure they do everything in house… if they outsource it and problems arise, it will be a headache getting your money back from that middle man because they can’t absorb the cost the way they would if it was their own print.

@der-kuenstler

Great looking cards DK.