That US IPC question (15 or 17) and IPC trackers

@Rescue55-joe I believe the “10 IPCs for each country” that you are referring to are actually the National Control Markers, which are used to track both conquered territories and national production levels. As barnee pointed out, IPCs are not physically provided, and the Rulebook instructs us to track them on paper, but any proxy (such as Monopoly money) will do. See page 7 of the Rulebook for details on both National Control Markers and IPCs.

In a nutshell, the National Production Track is used to chart your “income” using a National Control Marker. and every turn the “money” goes into your “bank account”, which is represented by IPCs, where it can be spent on new units (or saved for later).

I hope this helps.

@scottbrooks said in Combat Questions:

re: #2

So I fully understand, could you clarify / confirm?

Western US is a separate square from sea zone 42. In this case it is 2 moves to get from the land to Midway, in zone 43

You cross three borders (WUS to 42, 42 to 43, 43 to Midway) so it is three movement points.

If that is true, how does it work when attacking a zone like square 45 with Japan surrounded by sea? Using Midway as a staging point, is it 3 moves to get to the Japanese mainland (43->44, 44->45, 45->Japan)?

No. You would cross four borders: Midway to 43, 43 to 44, 44 to 45, 45 to Japan). Note that you would not be able to land your fighter then. So a fighter move would be impossible.

In case your fighter started from a carrier in SZ 43, it would be three movement points to attack Japan. You could land on a carrier in SZ 45, then, provided this can be established as valid landing point.

If this is true, can planes overfly an occupied sea zone (e.g., 45) to stage an attack on Japan?

Yes, but only in case you can - during combat move phase - demonstrate how to land them during noncombat move phase.

@RYNO87 said in Fighter and aircraft carrier questions:

If a fighter in EASTERN US wants to land on a carrier in SZ13, is that 2 moves or 3 bc you count the landing?

You don’t count the landing.
Rulebook 1941, page 23: “In other words, each time an air unit crosses a boundary between spaces, whether territories or sea zones, it uses 1 movement point.”
So your scenario takes two movement points.

Also, can you place a new fighter on a carrier adjacent to a industrial complex or does it have to start at the IC.

Rulebook 1941, page 20: “Place fighters either in territories containing eligible industrial complexes, or on your aircraft carriers in sea zones (even hostile ones) adjacent to such territories. You can even place new fighters on an aircraft carrier currently being mobilized. However, you cannot place a new fighter on a carrier owned by a friendly power.”

I have moved your topic to the 1941 forum.

@Midnight_Reaper thank you!

Thnx !! much appriciated :)

@Sir_Cala:

A submarine either attacks or submerge.

If it attacks and hits a unit with a surprise strike with no destroyer present. The ship that is chosen to be hit does not defend and is removed from the battle board. Exceptions are Battleships. They take 2 hits and the second hit removes of the battleboard.
Repeat steps 2-7 if combat continues.

If a submarine submerges it is not involved in any sea battle.

so is that to say that if a sub scores a hit with a surprise attack it destroys whatever unit it hits, with the exception of battle ships which would need to be hit by two surprise attacks? cause battle ships have a defence of 4

General Combat Sequence
Combat takes place over a number of rounds. Each battle round consists of several steps.
1. Place units along the battle strip
2. Submarine surprise strike or submerge (sea battles only)
3. Attacking units fire
4. Defending units fire
5. Remove defender�s casualties
6. Press attack or retreat
7. Conclude combat

step 2.
submarine surprise strike or submerge (sea Battles only)
This step is specific to attacking and defending submarines.
Before the general sea battle takes place (steps 3�5), both attacking and defending submarines choose to either make a
Surprise Strike die roll or submerge. However, if your opponent has a destroyer in the battle, your attacking or defending
submarines cannot submerge or make a Surprise Strike. Combat proceeds normally, and your submarines fire along with your
other units in step 3 or 4.
Submerge: Attacking or defending submarines that choose to submerge are immediately removed from the battle strip and
returned to the game board in the contested sea zone, removing them from the rest of that sea battle.
Players on both sides have to decide whether attacking and defending submarines will fire or submerge before rolling any dice.
The attacking player decides first.
Surprise Strike: Each attacking submarine conducting a Surprise Strike rolls one die, scoring a hit on a roll of �2� or less.
After the attacker has rolled for all attacking submarines, the defender chooses one sea unit for each hit scored and moves it
behind the casualty strip. (Submarines cannot hit air units.) Then each defending submarine conducting a Surprise Strike rolls
one die, scoring a hit on a roll of �1.� After the defender has rolled for all defending submarines, the attacker chooses one sea
unit for each hit scored and removes it from play.
Once all Surprise Strike rolls have been made, remove the defender�s casualties. This step is over for this round of
combat. Repeat this step during each round of combat as long as there are attacking and/or defending submarines and no
opposing destroyers. Any hits made during this step that do not destroy units (such as battleships) remain in effect until the
end of the combat.
Note: In both cases, attacking or defending, transports can be chosen as casualties only if there are no other eligible units.
You cannot choose submerged submarines as casualties since they have been removed from the battle.

If the enemy sub doesn’t choose to submerge first, both ships can attack it.  Only air units require a destroyer to allow them to attack subs.