Maofator's painted units

@Eric-Poppleton @GEN-MANSTEIN

Benefits of making all units AA.

No need separate AA gun, more space. Cheaper air and naval costs allow more different combination of purchases. It encourage German naval build up and two ocean going USA. Losing air unit isn’t a big deal anymore.

Though I have been still working on balancing units with each other after giving AA ability. I think I’m getting closer.

Further stacks do not increase AA possibilities. Only matter is amount of attacker planes. 1/6 shot down chance per attacker air unit.

I had to give ground forces +1 defense otherwise especially infantry would become so ineffective considering fighter has 2 defense and just 3ipc cost.

This is of course unplayable on board because of fractionel numbers and upkeep ( Yes there is also upkeep and method to buy 1 destroyer despite 3.5 ipc cost but its out of topic otherwise calculating massive stacks would be huge trouble). Its totally for TripleA I just wanted to learn with these unit set up, would air units be underpowered/overpowered or balanced?

The current unit set up like this (still progressing);

chart.png

i just started painting mine.  Use spray paint.  Use Krylon grey or white primer.  After it primed spray it with the color you want as the base gray, green, earth, etc.  Then add the finishing touches the cockpit, nose, tail colors, etc.  The spray paint gives you a nice even coat.  Go light and fast over the piece about 6 inches away .  if you go slow you’ll put on to much paint.  no good you lose detail.  If you really want a sharp looking piece add decals.

look at some of my pieces on combat miniatures face book site.

Jeff Cam.

@barnee thanks, I was inspired after watching Midway to do them like that, and to differentiate them from fighters for my less observant friends. I liked it so much I did my Stukas and Japanese tacs the same way as well.

I have seen lots of people here use acrylics and I have on occasion. Most of my paints are enamels though. I find that is stays wet longer (which is a good thing) and doesn’t clump up nearly as much on your brush. I also use enamels in my airbrush. I find that enamels are actually much easier to clean than acrylics. While acrylics are water soluble, they don’t just dissolve, especially if already dry. It involves a great deal of scrubbing and scraping. With enamels, all you need is some mineral spirits cleaner and it takes the paint right off with very little effort. Cleaning acrylic paint out of my airbrush was hell the first time I did it… never using acrylics in there again. In terms of the finish, I can only assume that enamels hold up better to bumps and scrapes than acrylic paint does.

Someone once asked if enamels, by default, have a glossy finish to them. They do not, as long as you are using flat enamels, which seem to be the standard. I use flats and they have an excellent, non-shiny finish. I feel like enamel colors are a little deeper too, on the whole, but I suppose it depends on the brand of acrylic you use. Vallejo seems to be a popular choice for acrylics. I use predominantly Model Masters (Testors) enamels. In general, I would just said to find a brand you like to work with and produces the results you like. Don’t buy super cheap paint… you will get the results you pay for.

Good luck!

Nice! I like how you kept some of the original piece color in the mix on the French Navy. Lookin’ good all around!