@The-Captain
I used 3mm thumb nuts drilled out to fit 3mm acrylic rods. I used a number of 3d printed jigs for cutting the rods, assembly of the stands and gluing the magnets. If I remember later I’ll attached some pictures of the jigs/stands
My solution for magnetic carriers and fighters
-
So, I have read a few posts about dealing with fighters and Tac bombers on carriers. I was at Hobby Lobby and came across “magnetic tape” for $5.99. After about an hour of experimentation, I am happy with the results. I even painted over the magnetic tape and primed the fighter to see how that might affect the magnetic strength. No issues thus far, so I will begin mass production tomorrow.
-
Good job :-D
-
Thanks.
-
Ready to be placed on the board.
Suggested Topics
